Sep-02
1	got wipers working.  Sawed switch in half, repaired loose rivet joint with solder, glued switch together.
	bled brakes.
4	removed gas tank - full of scale.  Took to Garry Rad next day.
	installed one seat belt.
	purchased mirror
6	finished installing left seat belt
	bolted down driver's seat.
	installed inside mirror
	started installing right seat belt.
10	fixed interior light - loose wire
	installed new washer bottle, cleaned out left nozzle.  Washers working.
11	installed gas tank
	engine ran smoothly and continuously.
	leak at top left of rad
	brake fluid levels down - leak somewhere
12	fixed rad leak with JB Weld underwater epoxy
	drove car several times on Craig and Eveline.  No problems other than throttle linkage dropped off.
	Starting to become confident in car's reliability.
	removed driver's door, enlarged adjustment holes and refitted.  Door closes much better.  Almost okay.
13	installed thermostat housings with no thermostat.
	Flushed rad.
	car running at mid-temp on gauge.
14	drove car to Gimli and back.
	on 2nd lap around track the throttle stuck.
15	replaced burnt heater fan motor with one from an Audi.
	installed heater (less hoses)
	tidied up plug wires
	checked car for safety.  Everything is 100%
	drove to bank with Cheryl
	in the evening drove across Selkirk bridge and down Henderson Highway to Lockport and home.
16	installed dash defroster vents and dash
	set timing so car will start better.
	worked on sun visor
18	car passed safety with no problems
	bought plates
19	removed thermostat housing.  Broke corner of housing and one bolt.
	It took three hours to get it off.
22	re-aligned driver side window frame and added rubber edging.
25	installed new thermostat and heater hoses